South Florida is hard on gas lines. High water tables, sandy and often acidic soil, and salt air off the coast corrode buried black iron and steel pipe faster than almost anywhere else in the country — it’s common for a line that passed inspection fifteen years ago to start leaking at a threaded joint today. A to Z Statewide Plumbing has repaired, replaced, and installed residential and commercial gas lines throughout Miami-Dade and Broward County since 1981, and we hold Florida Certified Plumbing Contractor license CFC1426919 for exactly this kind of regulated work. Natural gas and propane lines are never a DIY job — Florida Statute requires a licensed contractor, a permit, and an inspection for any gas piping work, and we handle all three.
Most residential calls fall into one of two categories: a leaking joint on older black iron pipe, or a failed flare or crimp fitting on CSST (corrugated stainless steel tubing) run to a newer appliance. Homes built before the mid-1990s across West Park, Hollywood, Miramar, and the older sections of Fort Lauderdale still run largely on black iron, and that’s where we find most corrosion-driven leaks — usually at a union, elbow, or where the pipe transitions from underground to above-grade. We locate the leak with a combustible gas detector rather than guessing from a bubble test alone, isolate the section, cut back to sound pipe, and re-thread or re-run before pressure testing the whole line to Florida Building Code — Fuel Gas requirements.
Adding a gas appliance means sizing the new run correctly for its BTU load, not just tapping into the nearest available line. We install and size gas piping for:
Every new installation is permitted, inspected, and pressure-tested before the appliance is connected.
Repair makes sense for an isolated joint failure on an otherwise sound line. Replacement is the right call when we're seeing corrosion at multiple points along the run, when the existing line can't support the added load of a new appliance or a generator, or when older CSST was installed without proper bonding — a known issue on pre-2006 CSST installs that increases lightning-strike risk, and one South Florida's storm frequency makes worth correcting rather than working around. We replace with black iron, bonded CSST, or flexible connectors depending on the run and local code, and we size the new line for both current and reasonably foreseeable future load.
Commercial gas work carries higher stakes and higher volume — a restaurant kitchen or hotel laundry running on a high-BTU manifold can't be down for a day while a repair gets scheduled. We service restaurant gas piping, commercial kitchen appliance hookups, multi-unit residential gas manifolds, and industrial supply lines throughout Miami-Dade and Broward County, including emergency commercial gas line repair when a leak or outage threatens to shut down service. Because we also handle grease trap and drain work for many of the same commercial kitchens, we're often already familiar with a property's full plumbing layout before the gas call comes in — which speeds up diagnosis on multi-tenant and older commercial buildings where original drawings are incomplete or missing.
Hialeah and Miami Springs both have a large share of homes built from the 1940s through the 1970s, which means a lot of original galvanized or early black iron gas piping still in the ground or run through crawlspaces near Miami International Airport. That older piping is exactly the profile we see fail first — at threaded joints, at the point pipe transitions from soil to slab, and at old shutoff valves that were never rated for today's appliance loads. We provide residential and commercial gas line repair, replacement, and installation throughout Hialeah and Miami Springs, and we pull the Miami-Dade County permits both cities require before any work begins.
Across Broward County — Hollywood, Pembroke Pines, Miramar, Sunrise, Plantation, Coral Springs, Oakland Park, and the surrounding cities — we handle the same full scope: residential and commercial gas line repair, gas line replacement, new installation, and emergency leak response, with all permits pulled through the relevant Broward County or municipal building department. Oakland Park and the older canal-front neighborhoods nearby tend to have a mix of galvanized and early CSST runs, which is where we most often find bonding and corrosion issues during a routine leak-detection call.
Every repair, replacement, and new installation is pressure-tested before we restore gas service — this is a Florida Building Code requirement, not an upsell. We also pull all required permits and coordinate inspections with the local building department in Miami-Dade, Broward, and Palm Beach Counties, so the work is documented and your property stays compliant if you sell or refinance.
Any one of these is worth an immediate call. Gas leaks don’t wait, and neither should you: (954) 981-2133.
Every job is priced after an on-site assessment, but here’s the realistic range for South Florida:
| Service | Typical Range |
|---|---|
| Gas line leak repair | $150 – $800 |
| New gas line installation (per linear foot) | $15 – $25+ |
| Full gas line replacement | $500 – $3,000+ |
| Gas appliance hookup (stove, grill, etc.) | $200 – $600 |
| Gas line pressure test | $75 – $150 |
Never choose a gas contractor on price alone — a bad gas line repair risks fire, explosion, or carbon monoxide exposure. Call (954) 981-2133 for a free on-site estimate.
Yes — absolutely. If you smell gas, leave the property immediately and do not use any electrical switches. Call your gas company to shut off supply, then call A to Z Plumbing at (954) 981-2133. We respond to gas emergencies 24/7.
No. Florida law requires gas line installation and repair to be performed by a licensed contractor. Attempting DIY gas line work is both illegal and extremely dangerous. Always call a licensed plumber like A to Z Statewide Plumbing.
Yes. All gas line work requires permits in Florida. We pull all required permits in Miami-Dade, Broward, and Palm Beach Counties and coordinate inspections with the local building department.
Minor gas line repairs typically take 1–3 hours. Full gas line replacements can take a full day or more depending on pipe length, access, and scope. We provide a time estimate before starting work.
Yes — this is one of the most common gas line jobs we do for South Florida homeowners. We install natural gas lines for outdoor grills, fire pits, outdoor fireplaces, and patio heaters. Call (954) 981-2133 for a free estimate.
Our licensed plumbers assess the pipe material, age, extent of damage, and location. Minor leaks at joints can often be repaired. Corroded, old steel pipes or CSST that has been compromised typically need full replacement for long-term safety.
Yes. We provide 24/7 emergency gas leak detection and repair throughout Hialeah, Miami Springs, and the rest of Miami-Dade County, with no overtime charge for nights, weekends, or holidays.
Yes. We install and repair commercial gas piping for restaurants, hotels, and commercial kitchens throughout Miami-Dade and Broward County, including high-BTU appliance hookups and multi-unit gas manifolds, and we pull all required commercial permits.
Full gas line replacement typically runs $500–$3,000+ depending on pipe length, material, and access. We give an exact quote after an on-site assessment — call (954) 981-2133.
Yes, Oakland Park is within our standard Broward County service area for gas leak detection, repair, replacement, and installation.
Contact us today for fast, reliable plumbing service. Our team is ready to help with all your plumbing needs.
(954) 981-2133
service@atozstatewideplumbing.com
Miami, Fort Lauderdale, West Palm Beach & surrounding areas
Regular hours: Mon-Fri 8am-6pm
Gas line problems are serious — and so are we. A to Z Statewide Plumbing has been safely installing and repairing gas lines throughout South Florida for over 45 years. We are licensed, insured, and available 24/7 with no overtime charges.
